PRODUCT CHARACTERISTIC
● Have two row of LED , one indicate local status, the other indicate remote status
● the interface of lan is 10/100M ,full/duplex auto-negotiation
● Provide two clock mode, fiber main clk and fiber line clk
● Have three LoopBack Mode: fiber interface LoopBack(ANA)、LAN interface LoopBack(DIG)、command the remote LAN interface LoopBack (REM)
● Realise auto-speed setting of local device to remote device
● Having pseudo random code test function, can used as a 2M Protocol Analyzer
● Ethernet support N*64k rates, rate from 64k to 2048k.
● Ethernet monitor can reset by itself，it won’t die
● Ethernet data suggested function, real-time indicate data communication state
● Provide 1-4 channels voice access, support calling indication
● Voice port supports O port and S port, O port connect with PBX, S port connect with phone users
Optical interface
● Optical wavelength: single mode 1310nm/1550nm
● Fiber: single fiber or double fiber for option
● Transmitting consumption: -9dBm/-5dBm
● Transmission range: 0-50Km/120Km for option
● Optical interface: SC/FC
● Receiving and dispatching module: >-6dBm
● Optical receiver receiving sensitivity <-36 dBm (BER<10-11)
● Fiber circuit code: NRZ code
10/100Base-T Ethernet Interface
● Rate: 10/100M, full/duplex auto-negotiation
● Protocol: Support IEEE 802.3, IEEE 802.1Q (VLAN)
● MAC Address Entiries: 4096 Entiries
● Total Memory Sizes: 64MBits SDRAM
● Physical interface: RJ45, support AUTO-MDIX
Voice Interface
FXS:
● Alarm voltage: 75V
● Alarmf requency: 25HZ
● 2 line input impedance: 600Ω (hanging off)
● Wastage: 40db
FXO:
● Alarm detecting voltage: 35V
● Alarm detecting frequency: 17HZ-60HZ
● 2 line input impedance: 600Ω (hanging off)
● Wastage: 40db
Power supply
● working voltage range wide, good
● anti-disturb and Isolation, work stable
● option I – DC,range DC-36V~DC-72C
● option II – AC,range AC90V~AC240V
● Power Consumption: <=3 Watts
environment condition
● Operating temperature: 0C~+50 C
● Storage temperature: -20 C~+70 C
● Relative temperature:95% (uncondensed)
Dimension
210mm(L) x 140mm(W) x 30mm(H)
Application 1
FXO---FXS
Application 2
FXS---FXS
Other devices,maybe you interstered:
FAQ:
Question: Can the Fiber Multiplexer be configured as 4Voice+4ETH+4RS232 with SNMP? If can, does the device have VLAN dip switch?
Answer: Yes, the Fiber Multiplexer can be configured as 4Voice+4ETH+4RS232 with SNMP. But the device doesn't have VLAN dip switch. VLAN cannot be set through SNMP, only can be set through console management.