Site map    Tel:+86-21-37709251    Contact Us Chinese
Ethernet over Coax converter Slave Unit with Wifi
Wifi Ethernet over Coax converter Slave Unit with four ethernet port

  Request price     Contact us

INFORMATION

Introduction

BD-EOC-S4-W is the EOC slave based on HomePlug AV solution for Ethernet access over coax. It works together with EOC master which is based on HomePlug AV solution as well to construct a two-layer Ethernet data transmission channel on CATV coax cable, provide the Ethernet access service based on the existing coax cable networking.

The built-in wifi module based on the single chip AR9331 which integrates an 802.11n 1x1 MAC/BB/ radio with internal PA and LNA. It supports 802.11n operations up to 72 Mbps for 20 MHz and 150 Mbps for 40 MHz channel respectively, and IEEE 802.11b/g data rates.

BD-EOC-S4-W is slave with 4 Ethernet ports with built-in Wifi.

 Function Features

  • Low-frequency modulated EOC slave is adopted INT7400 chipset, HomePlug AV solution
  • Work at low frequency between 7.5MHz and 65MHz, without affecting the existing CATV
  • Physical layer speed: 500Mbps; Max MAC layer throughout is 300Mbps
  • Support 4 Ethernet ports with 10/100Mbps auto-negotiation function
  • Support VLAN configuration based on slave unit or slave’s Ethernet ports
  • Support broadcast storm control
  • Support WEB, CLI and SNMP management

Wifi Features

  •  MIPS 24K processor operating at up to 400 Mhz.
  •  DD2 memory up to 512 Mb.
  •  SPI NOR Flash memory up to 64Mb.
  •  4LAN ports and 1 WAN port
  •  SPI support.

Standard and Protocol Supported

l        Network access

l        VOD(video on demand service)

l        IPTV

l        Video Surveillance

Application

ethernet over cable EOC application diagram

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Qustion and comment about EOC

 

Question: Does the EOC Question1: slave device supporting PPOE ?static IP and dhcp etc

Answer: Yes,the EOC slave with wifi device support these router function (PPPOE,static IP and DHCP etc).

             The EOC slave without the wifi,can not support the router functions.

Question2: Does the Wifi EOC slave unit support telnet management? If so,what is the user name and password?

Answer: BAUDCOM wifi EOC slave can be managed by TELNET,

             the management account information as below:

             IP address: 192.168.1.1

             user name: root

             password: root626  

              Note: The EOC slave device version information               

Hardware Version

v1.3

Firmware Version

V2.0.2-X000

Question3: Does the EOC SLAVE modem support SIP protocol for VOIP? Do you have an RJ11 port for telephone?

Answer: BAUDCOM EOC slave modem can transparently transmit the network data with SIP protocol.

             We can not provide the EOC slave modem with RJ11 telephone port.  

Question4: EOC Slave with wifi diplex is 42/54 Mhz?

Answer: Our EOC Slave with wifi diplex can be 42/54 Mhz. There are three options for customer choose: 30/47-42/54、65/87.



Ordering information


Related Products

Ethernet over Coax (EOC) Slave Unit

2-4 channels 100M Ethernet based on CATV coax cable

Ethernet over Coax converter Master side unit

Ethernet over Coax converter,master side